Figure 2. Removal of lower frontcasting.Figure 1. Removal of ignition barknob.Safety Upgrade InstructionsThese instructions are for the Valor Legend U
Safety Upgrade InstructionsPage 10Figure 17. Left cross logFigure 16. Front log3. Place the frontlog in the opening ofthe firebox base cover.Slide the
Safety Upgrade InstructionsPage 11Figure 18. Right cross log5. Place the right front log(stamped “R” underneath) over theother logs. Locate it over th
Safety Upgrade InstructionsPage 12Advise the customer that: -1. The battery should be replaced each season.2. If for any reason the fascia has been
Safety Upgrade InstructionsPage 2Figure 4. Fascia Removal on Cast Iron andStandard fascia.Figure 3. Removal of Screws on cast Iron fascia.Standard fas
Safety Upgrade InstructionsPage 3Figure 7. Fitting the locatingbracket.Figure 6. Removal of Bushing.Figure 5. Removal of Screw fromlocating bracket.2.
Safety Upgrade InstructionsPage 4Figure 8. Gas Valve3. Replacing the Gas ValveRefer to figure 8.1. Loosen the screw attaching the ignition bar to the
Safety Upgrade InstructionsPage 5Figure 10.Battery ReplacementFigure 9. Microswitch arm locationImportant Note:When connecting the ignition bar tothe
Safety Upgrade InstructionsPage 6Figure 11. Relief panels5. Relief Panel operationThe relief panels on the underside of the firebox should be held in
Safety Upgrade InstructionsPage 7Figure 12. Fascia locating6. Adjusting the height of the ignition barWhen refitting the Fascia it is important that t
Safety Upgrade InstructionsPage 8Figure 13 Ignition bar adjustment screw3. If the ignition bar does notlocate satisfactorilythrough the fascia, loosen
Safety Upgrade InstructionsPage 9Figure 15. Upper rear logFigure 14. Lower rear log7. Final ReviewReplace the ceramic fuel effect bed as below1. Place
Komentáře k této Příručce